Stamina-products AeroPilates XP615 Manual de usuario

Owner'sManual! WARNING !Exercise can present a healthrisk. Consult a physicianbefore beginning any exerciseprogram with this equipment.If

LOAD ADJUSTMENTThe resistance of the CARRIAGE(12) can be adjusted bysecuring the TENSION CORDS(15) in the slots located onthe FRONT FRAME(1). You can

STORAGETo store the AeroPilates Performer XP615 simply keep it in a clean dry place. The AeroPilates PerformerXP615 can be folded as illustrated for

MAINTENANCE12The safety and integrity designed into the AeroPilates Performer XP615 can only be maintained whenthe AeroPilates Performer XP615 is regu

13CONDITIONING GUIDELINESHow you begin your exercise program depends on your physical condition. If you have been inactive forseveral years or are se

14WARM-UP and COOL-DOWNWarm-up The purpose of warming up is to prepare your body for exercise and to minimize injuries. Warmup for two to five minu

Stamina Products, Inc. warrants that this product will be free from defects in materials and workmanshipunder normal use, service and proper operation

PRODUCT PARTS DRAWING16FRONTBACK

PARTS LIST DIAGRAM# PART NAME QTY 1 Front Frame 1 2 Rear Frame 1 3 Front Left Side Rail 1 4 Front Right Side Rail 1 5 Rear Left Side

PARTS LIST DIAGRAM# PART NAME QTY1849 Washer (M5) 750 Washer (M6) 251 Washer (M8) 2052 Washer (M10) 453 Lock Washer (M8) 454 Warnin

IMPORTANT : Before filling out the form below make sure you have the right information.Refer to the parts list to make sure you're ordering the

TABLE OF CONTENTS2Conditioning Guidelines 13Warm-up and Cool-Down 14Warranty 15Product Parts Drawing 16Parts List 17Fax/Mail Ordering Form 19

THANK YOU FOR PURCHASING THEAeroPilates Performer XP615To help you get started, we have pre-assembled most of yourAeroPilates Performer XP615 at the

BEFORE YOU BEGINTHE FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY : Combination WrenchSocket WrenchFront FrameFoam PadHead RestPulley AssemblyFront CoverH

5Part No. and Description Qty51 Washer (M8) 647 Nylock Nut (M8 x 1.25) 241 Screw, Round Head (M5 x 0.8 x 25mm) 429 Rubber Foot 455 Loc

ASSEMBLY INSTRUCTIONS Place all parts from the box in a cleared area and position them on the floor in front of you. Remove allpacking materials f

ASSEMBLY INSTRUCTIONS7STEP 2Remove your AeroPilates Performer XP615 from its packaging placing the product on its side, with theLOCKING PIN(30) side

STEP 5Remove the paper covering from the foam tape inside the FRONT COVER(7) and REAR COVER(8). Placethe FRONT COVER(7) over the FRONT FRAME(1). Place

9ASSEMBLY INSTRUCTIONSASSEMBLY INSTRUCTIONS(59) Front Stand( Wider )(61) Rear Stand( Narrower )SLOTSThe rubber feet of the AeroPilates Performer XP61